Field Description
• 2# < K#: QoS is activated on the inter-
face. The available bandwidth is distributed as “fairly” as pos-
sible among the (automatically detected) traffic flows in a
queue. Exception: High-priority packets are always handled
with priority.
• 5"1 (default value): QoS is deactivated on the inter-
face. The existing configuration is not deleted, but can be ac-
tivated again if required.
Traffic shaping Activate or deactivate data rate limiting in the send direction.
The function is enabled with "1.
The function is disabled by default.
Maximum Upload
Speed
Only for Traffic shaping = enabled.
Enter a maximum data rate for the selected interface in the
send direction in kbit per second.
Possible values are to .
The default value is , i.e. no limits are set, the selected inter-
face can occupy its maximum bandwidth.
Protocol Header Size
below Layer 3
Only for Traffic shaping = enabled.
Choose the interface type to include the size of the respective
overheads of a datagram when calculating the bandwidth.
Possible values:
• . $ : Value in byte.
Possible values are to .
• .$ %1 @ -$$L! (default
value)
Can only be selected for Ethernet interfaces
•
• E03)
•
• E03)
10 Networking bintec elmeg GmbH
268 bintec RS Series
To Next Page
Loading...
