Field Description
IP Address Mode Choose whether your device has a static IP address or is as-
signed one dynamically.
Possible values:
• 3 (default value): Your device is dynamic-
ally assigned an IP address.
• %: You enter a static IP address.
Default Route Select whether the route to this connection partner is to be
defined as the default route.
The function is enabled with "1.
The function is enabled by default.
Create NAT Policy Specify whether Network Address Translation (NAT) is to be ac-
tivated.
The function is enabled with "1.
The function is enabled by default.
Local IP Address Only for IP Address Mode = %
Enter the static IP address you received from your provider.
Route Entries Only if IP Address Mode = %
Define other routing entries for this connection partner.
Add new entries with Add.
• A 3: IP address of the destination host or
network.
• )9: Netmask for Remote IP Address If no entry is
made, your device uses a default netmask.
• '%: The lower the value, the higher the priority of the
route (range of values ... ). The default value is .
Fields in the IPv6 Settings menu
Field Description
IPv6 Select whether the selected ATM profile should use Internet
13 WAN bintec elmeg GmbH
320 bintec RS Series
To Next Page
Loading...
