Field Description
Protocol version 6 (IPv6) for data transmission.
The function is activated by selecting "1 .
The function is disabled by default.
Security Policy Select the security settings to be used with the ATM profile.
Possible values:
• . (default value): Only those packets are transmit-
ted that can be attributed to a connection that has been initi-
ated from a trusted zone.
We recommend you use this setting if you want to use IPv6
outside of your LAN.
• *: All IP packets are allowed through except for those
which are explicitly prohibited.
We recommend you use this setting if you want to use IPv6
on your LAN.
You can configure exceptions for the selected setting in the
Firewall on page 415 menu.
IPv6 Mode Only for IPv6 = "1
The selected PPPoE interface is operated in host mode.
Accept Router Advert-
isement
Only for IPv6 = "1 and IPv6 Mode = @
Determine if Router Advertisements are to be received over this
ATM profile. Router Advertisements are used to create the de-
fault router list as well as the prefix list.
The function is activated by selecting "1 .
The function is enabled by default.
DHCP Client
Only for IPv6 = "1 and IPv6 Mode = @
Determine if your device is to act as DHCP client.
The function is activated by selecting "1 .
The function is enabled by default.
bintec elmeg GmbH
13 WAN
bintec RS Series 321
To Next Page
Loading...
