Fields in the ATM Profiles Parameter menu.
Field Description
Provider Select one of the preconfigured ATM profiles for your provider
from the list or manually define the profile using .
$ .
Description Only for Provider = . $
Enter the desired description for the connection.
ATM Interface Only if several ATM interfaces are available, e.g. if several inter-
faces are separately configured in devices with SHDSL.
Select the ATM interface that you wish to use for the connec-
tion.
Type Only for Provider = . $
Select the protocol for the ATM connection.
Possible values:
• 3*' (default value): Ethernet over ATM
(EthoA) is used for the ATM connection (Permanent Virtual
Circuit, PVC).
• A %1 3*': Routed Protocols over
ATM (RPoA) is used for the ATM connection (Permanent Vir-
tual Circuit, PVC).
• 3*': PPP over ATM (PPPoA) is used for the ATM
connection (Permanent Virtual Circuit, PVC).
Virtual Path Identifier
(VPI)
Only for Provider = . $
Enter the VPI value of the ATM connection. The VPI is the iden-
tification number of the virtual path to be used. Note your pro-
vider's instructions.
Possible values are to .
The default value is .
Virtual Channel Identi-
fier (VCI)
Only for Provider = . $
Enter the VCI value of the ATM connection. The VCI is the iden-
bintec elmeg GmbH
13 WAN
bintec RS Series 339
To Next Page
Loading...
