The Additional IPv4 Traffic Filter parameter fixes this problem. You can filter more
"finely", i. e. you can, e. g., specify the source IP address or the source port. If there is a
Additional IPv4 Traffic Filter configured, it is used to negotiate the IPSec phase 2 SAs;
the route only determines which data traffic is to be routed.
If an IP packet does not match the defined Additional IPv4 Traffic Filter it is discarded.
If an IP packet meets the requirements in an Additional IPv4 Traffic Filter , IPSec phase 2
negotiation begins and data traffic is transferred over the tunnel.
Note
The parameter Additional IPv4 Traffic Filter is only relevant to the initiator of the
IPSec connection, it only applies to outgoing data traffic.
Note
Please note that the phase 2 policies must be configured identically on both of the
IPSec tunnel endpoints.
Add new entries with Add.
bintec elmeg GmbH
14 VPN
bintec RS Series 361
To Next Page
Loading...
