Field Description
• ' 6@3 (default value): Run MS-CHAP version 2 only.
• ): Some providers use no authentication. In this case, se-
lect this option.
Encryption
If necessary, select the type of encryption that should be used
for data traffic to the connection partner. If Encryption is set,
the remote terminal must also support it, otherwise a connection
cannot be set up.
Possible values:
• ): MPP encryption is not used.
• "1 (default value): MPP encryption V2 with 128 bit is
used to RFC 3078.
• 27 %+"1: MPP encryption V2 with 128 bit is
used as compatible with Microsoft and Cisco.
Compression
If necessary, select the type of encryption that should be used
for data traffic to the connection partner. If encryption is set, the
remote terminal must also support it, otherwise a connection
cannot be set up.
Possible values:
• ) (default value): Encryption is not used.
• *36
• ' *36
• '6: Microsoft Point-to-Point Compression
LCP Alive Check
Select whether the availability of the remote terminal is to be
checked by sending LCP echo requests or replies. This is re-
commended for leased lines, PPTP and L2TP connections.
The function is enabled with "1.
The function is enabled by default.
Fields in the IP Options menu.
Field Description
OSPF Mode Select whether and how routes are propagated via the interface
and/or OSPF protocol packets are to be sent.
bintec elmeg GmbH
14 VPN
bintec RS Series 407
To Next Page
Loading...
