Field Description
Possible values:
• (default value): OSPF is not activated for this inter-
face, i.e. no routes are propagated or OSPF protocol packets
sent over this interface. Networks reachable over this inter-
face are, however, included when calculating the routing in-
formation and propagated over active interfaces.
• 3%: OSPF is activated for this interface, i.e. routes are
propagated or OSPF protocol packets sent over this interface.
• %: OSPF is disabled for this interface.
Proxy ARP Mode Select whether your device is to answer APR requests from
your LAN on behalf of the specific PPTP partner.
Possible values:
• % (default value): Disables Proxy-ARP (Address
Resolution Protocol) for this PPTP partner.
• .+ 5: Your device only responds to an ARP re-
quest if the status of the connection to the PPTP partner is
.+ (active) or 5. In the case of 1, your device
only responds to the ARP request; the connection is not set
up until someone actually wants to use the route.
• .+ 1(: Your device answers an APR request only if the
status of the connection to the PPTP partner is 3%, i.e. if
a connection to the PPTP partner has already been estab-
lished.
DNS Negotiation Select whether your device receives IP addresses for Primary
DNS Server and Secondary DNS Server from the PPTP part-
ner or sends these to the PPTP partner.
The function is enabled with "1.
The function is enabled by default.
Fields in the PPTP Callback menu.
Field Description
Callback
Enables a PPTP tunnel through the Internet to be set up with a
PPTP partner, even if the partner is currently inaccessible. As a
rule, the PPTP partner will be requested by means of an ISDN
14 VPN bintec elmeg GmbH
408 bintec RS Series
To Next Page
Loading...
