Field Description
Possible values:
• * (default value): The operations configured and as-
signed in Actions are initiated at specific points in time.
• ':/)': The actions configured and assigned in Actions
are initiated when the defined MIB variables assumes the as-
signed values.
• $% : Operations configured and assigned in
Actions are initiated, when the defined interfaces take on a
specified status.
• $% *$$%: The operations configured and as-
signed in Actions are triggered if the data traffic on the spe-
cified interfaces falls below or exceed the defined value.
• # *: the operations configured and assigned in Ac-
tions are triggered if the defined IP address is accessible or
not accessible.
• 6$% 0$: Operations configured and as-
signed in Actions are initiated when the defined period of
validity is reached.
• <% : (not available on all devices): The option
<% : determines that pushing the function but-
ton on the device can serve as a trigger for any configured ac-
tion. Pushing the button for approx. one second (but less than
three seconds) sets the button status to 3%, pushing it
for more than three seconds sets it to %. Actions de-
pending on the state of the button are then carried out after
the next cyclical query determined by the Schedule Interval.
In this way, e.g., a WLAN interface can be activated when the
button is pushed for a second. Pushing the button for more
than three seconds deactivates the interface again.
• - P : Operations configured and assigned in
Actions are initiated, when the defined GEO Zones take on a
specified status.
Monitored GEO Zone
Only for Event Type - P
Select a GEO zone configured in the Physical Interfaces
menu.
GEO Zone Status
Only for Event Type - P
17 Local Services bintec elmeg GmbH
486 bintec RS Series
To Next Page
Loading...
