Canon LBP352 - Page 492

● When you press ( ), the print job is canceled.
Cannot store.
The SD card is set to <Off>.
● Set <SD Card> to <On>, and send the print data again.
SD Card(P. 369)
The upper limit on the volume of data that can be stored on the SD card has been exceeded.
● A maximum of 1000 data items can be stored in the machine. Delete unnecessary stored data.
Deleting a Document Stored in the Machine(P. 141)
Free space of the SD card is insucient.
● The SD card can store up to 3 GB of data in total. Delete unnecessary stored data.
An incorrect box number has been specied.
● Specify the correct box number.
Storing a Document in the Machine(P. 137)
● When you press ( ), the print job is canceled.
Cannot verify.
A department ID authentication error has occurred.
● Specify the correct department ID and password, and print the le again.
● If the print data does not support the department ID management, specify the setting to permit printing
with an unknown department ID, and print the le again.
Blocking Jobs When Department ID Is Unknown(P. 261)
● When you press ( ), the print job is canceled.
Check paper size.
The paper loaded in the paper source does not match the specied paper size.
● Specify the paper size correctly.
Specifying the Size and Type of the Paper in the Paper Drawer(P. 60)
Specifying Paper Size and Type in the Multi-Purpose Tray(P. 63)
Basic Printing Operations(P. 78)
When the paper size was set to <Free Size>, printing has been attempted with the custom size paper of
which long edge is 215.9 mm or less loaded in portrait orientation (only during use of the UFR II printer
driver).
Troubleshooting
485