● Load the paper in landscape orientation, and print the le again.
Printing has been attempted with the custom size paper loaded in landscape orientation without the
UFR II printer driver used.
● Load the paper in portrait orientation, and print the le again.
<Check Paper Size> is set to <On>.
● Set <Check Paper Size> to <Off>, and print the le again.
Check Paper Size(P. 407)
Consmbl. status print. Press Utility key.
A warning message about toner cartridge has been issued.
● Check the message by Consumables Status Print.
Consmbl. Status Prt.(P. 537)
D7 nn Error (nn: 2-digit alphanumeric)
An abnormality has occurred in the machine, resulting in malfunction.
● Shut down the machine, wait for 10 seconds or more, and turn ON the power again.
Turning ON/OFF the Power(P. 33)
D8 nn Error (nn: 2-digit alphanumeric)
An abnormality has occurred in the machine, resulting in malfunction.
● Shut down the machine, wait for 10 seconds or more, and turn ON the power again.
Turning ON/OFF the Power(P. 33)
D9 nn Error (nn: 2-digit alphanumeric)
An abnormality has occurred in the machine, resulting in malfunction.
● Shut down the machine, wait for 10 seconds or more, and turn ON the power again.
Turning ON/OFF the Power(P. 33)
Data receiving error.
When you are using a printer driver other than the supplied one, [Dedicated Port Authentication
Method] of the Remote UI is set to [Mode 2].
● When you are using a printer driver that allows you to select the authentication mode for Department ID
Management and Secured Print, select Mode 2.
● When you are using a printer driver that does not allow you to select the authentication mode, set
[Dedicated Port Authentication Method] of the Remote UI to [Mode 1].
Log on to the Remote UI in Management Mode ( Starting Remote UI(P. 333) ) [Settings/
Registration] [Network] [Dedicated Port Settings] [Edit] Select [Mode 1] in [Authentication
Method] [OK] Perform a hard reset ( Performing a Hard Reset(P. 451) )
Troubleshooting
486
To Next Page
Loading...
