SECTION 58 - ATTACHMENTS / HEADERS - CHAPTER 1
58-19
6. Remove the two special bolts, 1, and nuts from
each end of the cutter bar attaching arms. Drive
the bushings out of the arms with a punch.
WARNING
Disengage the PTO, turn off the tractor engine
and remove the key. Wait for all movement to
stop before leaving operator’s position. Never
adjust, lubricate, clean or unplug machine with
the engine running. Failure to comply could
result in death or serious injury.
1
A3658-21
41
NOTE: If the cutter bar mounting bolts do not drive
out easily, slightly raise or lower the cutter bar using
the floor jacks.
Retain the special bolts, 1, and nuts, 2, used to
retain the cutter bar; remove the nuts and slide
the bolts out of the attaching arms.
50012158
1
2
42
7. Lower the floor jacks and roll the cutter bar out
from under the header.
NOTE: The drive shaft will slide off the bevel gearbox
output shaft and stay with the cutter bar.
50012159
43
To Next Page
Loading...
