Configuring Security, Quality, and Network Features
Configuring Domain and Internet Settings
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 142
5
STEP 3 Click the System tab.
STEP 4 Configure the following fields:
• Static IP Address—Enter the static IP address of the phone.
• Netmask—Enter the subnet mask of the phone.
• Gateway—Enter the IP address of the gateway.
For the SPA525G
/525G2, you also have the following fields available:
• LAN MTU—LAN Maximum Transmission Unit size. Default value: 1500.
• Duplex Mode—Choose one of the following to configure the speed/duplex
for the phone’s Ethernet ports:
- Auto
- 10MBps/Duplex
- 10MBps/Half
- 100Mbps/Duplex
- 100MBps/Half
STEP 5 Click Submit All Changes.
NOTE For the Cisco SPA301 and Cisco SPA501G, can be configured using the IVR. See
the “Using IVR on the Cisco SPA301 and Cisco SPA501G IP Phone” section on
page 29.
Configuring PPPoE Settings (Cisco SPA525G/525G2 only)
If you configured PPPoE as the internet connection type:
STEP 1 Log in to the configuration utility.
STEP 2 Click Admin Login and advanced.
STEP 3 Click the System tab.
To Next Page
Loading...
Need help?
General
