Cisco SPA IP Phone Field Reference
System Tab
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 237
B
VLAN Settings
NOTE Not applicable to the WIP310.
DNS Query Mode Do parallel or sequential DNS Query. With parallel DNS
query mode, the IP phone sends the same request to
all the DNS servers at the same time when doing a
DNS lookup, the first incoming reply is accepted by the
IP phone.
Defaults to parallel.
Syslog Server Specify the syslog server name and port. This feature
specifies the server for logging IP phone system
information and critical events. If both Debug Server
and Syslog Server are specified, Syslog messages are
also logged to the Debug Server.
Debug Server The debug server name and port. This feature
specifies the server for logging IP phone debug
information. The level of detailed output depends on
the debug level parameter setting.
Debug Level The debug level from 0-3. The higher the level, the
more debug information is generated. Zero (0) means
no debug information is generated. To log SIP
messages, you must set the Debug Level to at least 2.
Defaults to 0.
Primary NTP Server IP address or name of primary NTP server.
Secondary NTP Server IP address or name of secondary NTP server.
Enable Bonjour (SPA525G/
525G2 only)
Enable Bonjour networking that is used by Office
Manager and Cisco Configuration Assistant to discover
the Cisco IP phones. Choose yes to enable or no to
disable.
Parameter Description
Parameter Description
Enable VLAN Choose Yes to enable VLAN. Choose no to disable.
To Next Page
Loading...
Need help?
General
