Cisco SPA303 Administration Guide

Configuring Regional Parameters and Supplementary Services
Localizing Your IP Phone
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 193
7
The save-time value is the number of hours, minutes, and/or seconds to add to the
current time during DST. The
save-time value can be preceded by a plus (+) or
minus (-) sign to indicate addition or subtraction.
Daylight Saving Time Examples
The following example configures daylight saving time for the U.S, adding one hour
starting at midnight on the first Sunday in April and ending at midnight on the last
Sunday of October; add 1 hour (USA, North America):
start=4/1/7/0:0:0;end=10/31/7/0:0:0;save=1
start=4/1/7;end=10/-1/7;save=1
start=4/1/7/0;end=10/-1/7/0;save=1
The following example configures daylight saving time for Egypt, starting at
midnight on the last Sunday in April and ending at midnight on the last Sunday of
September:
start=4/-1/7;end=9/-1/7;save=1 (Egypt)
The following example configures daylight saving time for New Zealand, starting
at midnight on the first Sunday of October and ending at midnight on the third
Sunday of March. This only applies to countries that recognize daylight saving
time.
start=10/1/7;3/22/7;save=1 (New Zealand)
The following example reflects the new change starting March 2007. DST starts on
the second Sunday in March and ends on the first Sunday in November:
start=3/8/7/02:0:0;end=11/1/7/02:0:0;save=1
Selecting a Display Language
This section describes how to localize the Cisco SPA300 and Cisco SPA500
Series IP Phone display language. You can define up to nine languages, in addition
to English, to be available and host the dictionaries for each of the languages on
the HTTP or TFTP provisioning server. Language support follows Cisco dictionary
principles.
NOTE The WIP310 does not support localization; however, daylight saving time
adjustment is supported.
Use the Language Selection parameter to select the phone’s default display
language. The value must match one of the languages supported by the dictionary
server. The script (dx value) is as follows:

Cisco SPA303 Specifications

General

Display	Monochrome LCD
Lines	3
Speakerphone	Yes
Headset Jack	Yes (2.5 mm)
Handset	Yes
Ethernet Ports	2 x 10/100 Mbps
Protocol	SIP
Power	Power over Ethernet (PoE) or AC adapter
Audio Codec Support	G.711, G.729
QoS	802.1p/q