Configuring the Cisco SPA500S Attendant Console
Monitoring the Cisco SPA500S
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 219
9
Monitoring the Cisco SPA500S
To display the status of the Cisco SPA500S, click the Attendant Console Status link
on the GUI. The status of each attendant console attached (Unit 1 and Unit 2) is
shown. Parameters are read-only.
Cisco SPA500S Unit Monitoring Notes
The following table describes each parameter; both units display the same
parameters.
Parameter Description
Unit Enable Displays if the Unit is enabled or disabled.
Subscribe Expires Displays when the current subscription expires. After
the subscription expires, the Cisco SPA500S
automatically requests a new subscription.
HW Version Displays the version of the hardware.
Unit Online Displays whether the unit is connected or not.
Subscribe Retry Interval Displays the length of time the Cisco SPA500S waits to
try again if subscription fails.
SW Version Displays the version of the software currently running
on the unit.
Key Name Displays the name assigned to each key (1-32) on the
Cisco SPA500S attendant console unit.
Type Displays the function enabled for each key (1-32) on the
Cisco SPA500S attendant console unit.
Line Displays the extension assigned to each key (1-32) on
the Cisco SPA500S attendant console unit.
Station Displays the subscribe URI configured for each key (1-
32) on the Cisco SPA500S attendant console unit.
Subscribe Displays the subscription status of the unit/key. The
value can be Yes, Fail, or No. No indicates that the
feature/function (fnc) of that line does not require a
subscription (such as speed dial).
To Next Page
Loading...
Need help?
General
