Cisco SPA303 Administration Guide

Cisco SPA IP Phone Field Reference
Info Tab
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 226
B
Cisco SPA525G/525G2-Specific Parameters:
Network Configuration (SPCP)
Parameter Description
NTP Enable Shows if Network Time Protocol is enabled.
Primary NTP Server IP Address of the primary NTP server.
Secondary NTP Server IP Address of the secondary NTP server.
TFTP Server Address of the TFTP server for provisioning.
Bluetooth Enabled Shows if Bluetooth is enabled.
Bluetooth Firmware Version Displays the Bluetooth firmware version.
Bluetooth Connected Shows if a Bluetooth device is connected to the phone.
Bluetooth MAC Shows the hardware address of the Bluetooth device.
Connected Device ID Shows the name of the connected Bluetooth device.
Wireless Enabled Shows if Wireless-G is enabled on the phone.
Wireless Connected Shows if the phone is connected to the wireless
network.
Wireless MAC Shows the hardware address of the Wireless-G
controller.
SSID Shows the SSID, or name of the wireless router to
which the phone is connected.
Standard Channel Shows the wireless channel being used in the wireless
connection.
Security Mode Shows if wireless security is configured on the phone
(yes or no).
Parameter Description
TFTP Server Address of the TFTP server for provisioning.

Cisco SPA303 Specifications

General

Display	Monochrome LCD
Lines	3
Speakerphone	Yes
Headset Jack	Yes (2.5 mm)
Handset	Yes
Ethernet Ports	2 x 10/100 Mbps
Protocol	SIP
Power	Power over Ethernet (PoE) or AC adapter
Audio Codec Support	G.711, G.729
QoS	802.1p/q