Cisco SPA303 Administration Guide

Cisco SPA IP Phone Field Reference
Ext Tab
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 294
B
Ext Tab
The Ext tabs vary by phone and depend on the number of extensions the phone
model supports.
This section describes the fields for the following Ext tab headings:
• General, page 274
• Share Line Appearance, page 295
• NAT Settings, page 296
• Network Settings, page 296
• SIP Settings, page 297
• Call Feature Settings, page 301
• Proxy and Registration, page 304
• Subscriber Information, page 306
• Audio Configuration, page 307
• Dial Plan, page 310
PSK1 through PSK6 To configure a speed dial script, enter the following
in the PSK field:
fnc=sd;ext=
extensionname @$PROXY;vid= outbound
extnum
;nme= name
where fnc is the function of the key (speed dial), ext
(
extensionname ) is the extension being dialed, vid is
the extension on the calling phone from which the
outbound call is sent, and
name is the name of the
speed dial being configured.
To configure an XML script, enter the following in the
PSK field:
fnc=xml;url=http://
scriptURL.xml ;nme= scriptname
where fnc is the function of the key (an XML script),
scriptURL.xml is the URL where the script is located,
and
scriptname is the name of the script.
Parameter Description

Cisco SPA303 Specifications

General

Display	Monochrome LCD
Lines	3
Speakerphone	Yes
Headset Jack	Yes (2.5 mm)
Handset	Yes
Ethernet Ports	2 x 10/100 Mbps
Protocol	SIP
Power	Power over Ethernet (PoE) or AC adapter
Audio Codec Support	G.711, G.729
QoS	802.1p/q