Customizing Cisco SPA and Wireless IP Phones
Configuring Phone Information and Display Settings
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 51
3
Configuring the Screen Saver
You can configure a screen saver for the Cisco SPA300 Series and Cisco SPA500
Series IP Phones. (Not applicable to WIP310.)
This option enables a screen saver on the phone’s LCD. When the phone is idle for
a specified time, it enters screen saver mode. (Users can set up screen savers
directly using phone’s Setup button.)
Any button press or on/off hook event triggers the phone to return to its normal
mode. If a user password is set, the user must enter it to exit screen saver mode.
To configure the screen saver:
Cisco SPA303 or Cisco SPA50XG:
STEP 1 Log in to the configuration utility.
STEP 2 Click Admin Login and advanced.
STEP 3 Click the Phone tab.
STEP 4 In the General section, in the Screen Saver Enable field, choose yes.
STEP 5 In the Screen Saver Wait field, enter the number of seconds of idle time to elapse
before the screen saver starts.
STEP 6 In the Screen Saver Icon field, choose the display type:
• A background picture.
• The station time in the middle of the screen.
• A moving padlock icon. When the phone is locked, the status line displays a
scrolling message “Press any key to unlock your phone.”
• A moving phone icon.
• The station date and time in the middle of the screen.
• A blank “power save” screen.”
STEP 7 Click Submit All Changes.
To Next Page
Loading...
