Cisco SPA IP Phone Field Reference
Phone Tab
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 286
B
Multiple Paging Group Parameters
BroadSoft Settings
The Cisco SPA300 Series and Cisco SPA500 Series supports the BroadSoft
directory feature and synchronization of Do Not Disturb and Call Forward. The
following configuration fields are available:
Parameter Description
Group Paging Script You can configure a phone as part of a paging group.
Users can then direct pages to specific groups of
phones. A phone can be part of no more than two
paging groups, and user can page a maximum of five
paging groups.
The syntax is as follows:
pggrp=ip-address:port;[name=xxx;]num=xxx;
[listen={yes|no}]];
Where:
IP address
: Multicast IP address of the phone that will
listen for and receive pages.
port
: Port on which to page; you must use different
ports for each paging group.
name (optional): The name of the paging group.
num: The number users will dial to access the paging
group; must be unique to the group.
listen: If the phone should listen on the page group. Only
the first two groups with listen set to yes will listen to
group pages. If the field is not defined, the default value
is no, so you must set this field to listen to the group
pages.
To Next Page
Loading...
Need help?
General
