Customizing Cisco SPA and Wireless IP Phones
Configuring Lightweight Directory Access Protocol (LDAP) for the Cisco SPA300 Series and Cisco SPA500
Series IP Phones
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 85
3
STEP 3 Click the Phone tab.
STEP 4 Under Web Serv, choose yes.
STEP 5 Click Submit All Changes.
Configuring Lightweight Directory Access Protocol (LDAP) for
the Cisco SPA300 Series and Cisco SPA500 Series IP Phones
The Cisco SPA300 Series and Cisco SPA500 Series IP Phones support
Lightweight Directory Access Protocol v3 to enable the retrieval of directory
information. The LDAP Corporate Directory Search feature, when configured and
enabled on a Cisco SPA300 Series or Cisco SPA500 Series IP Phone, allows a
user to search a specified LDAP directory for a name, phone number, or both.
(LDAP is not supported on the WIP310.)
LDAP-based directories, such as Microsoft Active Directory 2003 and OpenLDAP-
based databases, are supported.
These instructions assume you have the following equipment and services:
• A functional LDAP server such as OpenLDAP or Microsoft's Active Directory
Server 2003
• A Cisco SPA300 Series or Cisco SPA500 Series IP Phone running at least
6.1.3a software on a functional network
Users access LDAP from the Directory menu on their IP phone. There is a limit of
20 records returned from an LDAP search.
Before you use the LDAP Corporate Directory Search feature of your phone, you
need to configure some basic information.
STEP 1 Log in to the configuration utility.
STEP 2 Click Admin Login and advanced.
STEP 3 Click the System tab.
STEP 4 In the Optional Network Configuration section, under Primary DNS, enter the IP
address of the DNS server. (Only required if using Active Directory with
authentication set to MD5.)
To Next Page
Loading...
Need help?
General
