Configuring Regional Parameters and Supplementary Services
Localizing Your IP Phone
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 194
7
• <Language_Selection ua="na">
• </Language_Selection>
Defaults to blank; the maximum number of characters is 512. For example:
<Language_Selection ua="na"> Spanish
</Language_Selection>
During startup, the phone checks the selected language and downloads the
dictionary from the TFTP/HFTP provisioning server indicated in the phone’s
configuration. The dictionaries are available at the support website. See
Appendix C, “Where to Go From Here,” for the website location.
The end user can change the language of the phone on the phone by following
these steps:
STEP 1 Press the Setup button.
STEP 2 Select Language, then press the Select soft button.
STEP 3 Select Option to change the language.
STEP 4 With the desired language selected, press Save.
Creating a Dictionary Server Script
The Dictionary Server Script defines the location of the dictionary server, the
languages available and the associated dictionary. The syntax is as follows:
Dictionary_Server_Script ua="na"/Dictionary_Server_Script
Defaults to blank; the maximum number of characters is 512. The detailed format
is as follows:
serv={server ip port and root path};
d0=language0;x0=dictionary0 filename;
d1=language1;x1=dictionary1 filename;
d2=language2;x2=dictionary2 filename;
d3=language3;x3=dictionary3 filename;
d4=language4;x4=dictionary4 filename;
d5=language5;x5=dictionary5 filename;
d6=language6;x6=dictionary6 filename;
d7=language3;x7=dictionary7 filename;
d8=language8;x8=dictionary8 filename;
d9=language5;x9=dictionary9 filename;
To Next Page
Loading...
Need help?
General
