Configuring the Cisco SPA500S Attendant Console
Setting Up the Cisco SPA500S Attendant Console
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 218
9
.
Parameter Description
Subscribe Expires Specifies how long the subscription remains valid.
After the specified period of time, elapses, the Cisco
SPA500S initiates a new subscription.
Defaults to 1800.
Subscribe Retry Interval Specifies the length of time to wait to try again if
subscription fails.
Unit 1 Enable Enables or disables the first Cisco SPA500S unit (each
phone can have up to two Cisco SPA500S units
attached).
Unit 2 Enable Enables or disables the second Cisco SPA500S unit
(each phone can have up to two Cisco SPA500S units
attached).
Subscribe Delay Length of delay before attempting to subscribe.
Defaults to 1.
Server Type Selects the type of server used (SPA9000, BroadSoft,
or Asterisk).
Test Mode Enable Enables or disables test mode. When test mode is
enabled, the LEDs are turned on when keys are
pressed, going from off to green to red, and back to off.
In test mode, when all the buttons on the attendant
console are returned to off, all the keys become
orange. The phone must be rebooted after the test is
completed.
Attendant Console Call
Pickup Code
The star code used for picking up a ringing call.
Defaults to *98 (group call pickup).
For directed call pickup, enter *97#. The user enters
*97 and the extension to pick up.
BLF List URI Automatically configures BLF subscriptions for all
users on a monitored list.
Unit 1 Key 1-32 Enter a strings that define the extension and other
parameters associated with each lighted button on the
first Cisco SPA500S unit. Keywords and values are
case-sensitive. The configuration script is described in
“Unit/Key Configuration Scripts” section on
page 214
.
To Next Page
Loading...
Need help?
General
