Getting Started
Using IVR on the Cisco SPA301 and Cisco SPA501G IP Phone
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 31
1
170 Recites the HTTP port on which the web server listens. Defaults to 80.
180 Recites the IP multicast address (used by the Cisco SPA 9000 to
communicate with the IP phone).
220 Recites the method of call control (SIP or SPCP).
221 Set call control—enter the value for the call control method you want,
then press #:
• 0: SIP
• 1: SPCP
To s a v e , p r e s s 1; to review, press 2; to re-enter, press 3; to exit, press *.
73738 Restores the phone to the factory default software and settings.
Enter 1 to confirm, or * to exit. If you chose to reset, hang up to exit and
begin the restore process.
87778
(Cisco
SPA501G)
Restore the phone’s user settings to the default. (Clears all user settings
such as speed dials.)
Enter 1 to confirm, or * to exit. If you chose to reset, hang up to exit and
begin the restore process.
732668 Reboot the phone. After entering #, hang up to begin rebooting.
111 Set a static IP address. Enter the address (use * to enter the “.” value),
then press #.
To s av e , p r e s s 1; to review, press 2; to re-enter, press 3; to exit, press *.
NOTE DHCP must be disabled to use this option; if DHCP is not
disabled, you receive an error message.
121 Set a netmask. Enter the address (use * to enter the “.” value), then
press #.
To s av e , p r e s s 1; to review, press 2; to re-enter, press 3; to exit, press *.
NOTE DHCP must be disabled to use this option; if DHCP is not
disabled, you receive an error message.
Number Option
To Next Page
Loading...
Need help?
General
