OPERATING THE TRANSCEIVER
DATA OPTIONS
98 ENVOY® TRANSCEIVER GETTING STARTED GUIDE
1 Compose your email message in your email client software,
for example Microsoft® Outlook®, then send it to the
recipient.
When a signal is transferred between the data modems
across the link established by the transceivers, the current
transmit or receive data rate is indicated on the right-hand
side of the Clear Data indicator.
While the message is being sent between the transceivers,
activity is reported on the screen of the control point.
Figure 25: Transmit and receive screens during a
MIL/STANAG 2G data call
NOTE: An AES-256 data encryption upgrade is
available for use with the MIL/STANAG 2G
Data interface.
NOTE: If you go off line in RC50-C, the modem may
disconnect for 15 sec, then reconnect.
Related links:
Using encryption on page 103
Transmit Receive
Clear data 9600
Clear data 9600
Clear Voice Clear Voice
To Next Page
Loading...
