OPERATING THE TRANSCEIVER
CALLING
58 ENVOY® TRANSCEIVER GETTING STARTED GUIDE
1 If prompted, press or to scroll to the channel that you
want to use, then press CALL.
A is shown next to the currently selected channel/mode.
To abort the call before it is answered, press PTT or SCAN.
There will be audible beeps or a pop-up message to indicate
that the call has been successful.
NOTE: If Settings > Calling > General > LBT
Mode is set to Enabled or Override
allowed, you may be asked to make the call
again if the channel is occupied.
Related links:
Entering text in a field on page 155
Entering text with the 2221 Handset on page 158
Entering text with a USB keyboard on page 159
Receiving a call
Some calls that are addressed to your station are handled
automatically by your transceiver. It will either respond
automatically with the information requested in the call that it
received (Get Position, Get Status, Channel Test, or ALE Sounding
call), or receive the message (Message, Send Position, SMS or
Web Message call). The remaining call types (Selective, Phone,
and Emergency) sound an alarm at your station.
For incoming ALL, ANY, Group Selective, and Wildcard calls to
multiple control points, any control point that has a matching
address will receive the call, if permitted. You may have to switch
off mute and change the mute type to be able to hear the
conversation.
Selective and Phone calls sound an alarm that is similar to a
telephone ringing. An Emergency call sounds a hee-haw alarm.
To Next Page
Loading...
Need help?
General
