Codan Envoy Getting Started Guide

USING THE WIZARD
USING THE WIZARD
28 ENVOY® TRANSCEIVER GETTING STARTED GUIDE
Selecting a peripheral device
When you select the peripheral device from the list, the transceiver
automatically sets these properties. The default settings should be
adequate for most situations, however, if you have special
requirements, please see the Reference Manual (Codan part
number 15-04176-EN issue 7) for more detailed information.
NOTE: Codan peripheral devices are listed by their type
number, for example, 3031 Crosspatch. The type
number for a Codan device is located on the front or
serial number escutcheon.
To select a peripheral device:
1 Press or to scroll to the type of peripheral device that
is attached to the connector, then press OK.
If there are settings that you can change to customise this
peripheral for your requirements, is shown to the right of
the peripheral name when it is selected.
1 If you want to change settings for the peripheral, press to
see the list of entries that you may change.
If the value of an entry for a peripheral device has been
changed from the default value, is shown next to the title
of the entry.
1 Press (Save) to automatically update settings for
correct operation of the connected peripheral device.
1 Press OK to close the wizard.
1 If you added a peripheral device, and a prompt to restart the
transceiver is displayed, accept it to to activate the new
settings.

Codan Envoy Specifications

General

Brand	Codan
Model	Envoy
Category	Transceiver
Language	English