OPERATING THE TRANSCEIVER
CALLING
ENVOY® TRANSCEIVER GETTING STARTED GUIDE 51
1 Press or to select the call type that you want to use.
1 Continue from making your chosen call type.
Related links:
Viewing missed calls on page 60
Making a call from the Emergency key
You can set up an emergency contact with calls that are chained
together when you hold the key. Emergency contacts are set up
in User Data > Contacts > Emergency Contacts.
CAUTION: If you have more than one emergency contact, you
will be prompted to select the emergency contact
who you want to call at the time of the call.
NOTE: For more information, please see the Reference
Manual (Codan part number 15-04176-EN issue 7).
To make a call from the Emergency key:
1 Hold for 2 sec.
1 If you have more than one emergency contact, scroll to the
contact who you want to call, then press CALL.
1 If prompted, press or to scroll to the channel that you
want to use, then press CALL.
A is shown next to the currently selected channel/mode.
To abort the call before it is answered, press PTT or SCAN.
There will be audible beeps or a pop-up message to indicate
that the call has been successful.
NOTE: Calls made from the key always override
LBT mode if it is enabled.
NOTE: If there are several calls programmed for this
emergency contact, the transceiver proceeds
with the next call following a pre-defined
pause.
To Next Page
Loading...
Need help?
General
