OPERATING THE TRANSCEIVER
THE CHANNEL SCREEN
ENVOY® TRANSCEIVER GETTING STARTED GUIDE 31
The channel screen
The channel screen shows the following information:
• the name of the currently selected channel
NOTE: If ... is shown before the channel name, then
this channel is contained within a channel
group.
• the transmit and receive frequencies, if applicable
• the status areas that show specific information about the
transceiver
• a bar graph that indicates the signal strength on receive
(green) and the output power on transmit (red)
• the transmit power level setting
• the call type icon (when calling) or the scan indicator (when
scanning, see Figure 8)
• the mute type indicator
• a missed call icon, if applicable
• the mode
• the crosspatch indicator, if connected
• the clarifier indicator, if set
• calling and system locks when the RFU is being used by a
connected data application or another control point (see
Figure 7)
To Next Page
Loading...
Need help?
General
