OPERATING THE TRANSCEIVER
CALLING
ENVOY® TRANSCEIVER GETTING STARTED GUIDE 63
Making a call when multiple control points are
connected to the same RFU
When multiple control points are connected to the same RFU and
a call is made, certain activities may be excluded if the control point
does not have control of the call. If two or more control points have
the same self address registered for use in the HF network, and one
of these stations makes a call, then any control points with the same
self address also have control of the outgoing call. PTT is on a
first-come, first-served basis, and all other control points are not
able to PTT while the RFU is in the transmit state. Control points
that have a different self address registered may be able override
calling and system locks.
NOTE: For more information on registering a self address
for your control point, see the Reference Manual
(Codan part number 15-04176-EN issue 7).
Control points that have control of a call show the same calling
information. Control points that do not have control of the call
show a System busy pop-up if an attempt to interrupt or join the
call is made. You may have to switch off mute and change the mute
type to be able to hear the conversation.
Figure 14: Calling information when multiple control points
are connected
You may be able to override this lock, depending on the value set
in Settings > Calling > General > Calling Lock Override.
control point with
control of a call
control point without
control of a call
To Next Page
Loading...
Need help?
General
