OPERATING THE TRANSCEIVER
SWITCHING THE TRANSCEIVER ON AND OFF
30 ENVOY® TRANSCEIVER GETTING STARTED GUIDE
Switching the transceiver on and off
Switching on the transceiver
To switch on the transceiver:
1 Press .
The template screen, then the welcome screen (if set) are
shown briefly, followed by the channel screen.
Switching off the transceiver
The power-down function controls which modules are switched
off. In some instances, it may only be the control point that
switches off and the RFU remains powered. The default behaviour
is for both the control point and the RFU to switch off.
To switch off the transceiver:
1 Do one of the following:
• Hold for 2 sec, then release.
• Press , then press OK.
The transceiver is switched off.
NOTE: For more information on the power-down
function, see the Reference Manual (Codan
part number 15-04176-EN issue 7).
To Next Page
Loading...
