OPERATING THE TRANSCEIVER
USING THE MICROPHONE
44 ENVOY® TRANSCEIVER GETTING STARTED GUIDE
Using the microphone
The microphone on the handset is located at the top between the
and keys. When you talk into the microphone:
• hold the microphone side-on and close to your mouth
• hold down PTT
• speak clearly at your normal volume and rate
• release PTT to return to receiving mode
On the desk console, you can speak directly into the boom
microphone.
NOTE: By default, the transceiver is set up to transmit a
short beep when you release PTT. This removes the
need for you to say ‘over’ at the end of your
transmission.
CAUTION: Your conversation can be monitored by anyone
tuned to your transmit frequency, unless you are
using one of Codan’s encryptors. Your signal can
potentially travel very large distances.
If PTT is held continuously for a certain length of time, the system
stops transmission, switches to receive and shows an error message
on the control point. This ensures that, even if the PTT button is
being held down accidentally, the battery will not be flattened, and
your transceiver is ready to receive calls.
You can set the length of time the system waits before it cuts
transmission (default is 10 min), or switch off this feature.
To Next Page
Loading...
Need help?
General
