INTRODUCTION
OVERVIEW OF THIS GUIDE
2ENVOY® TRANSCEIVER GETTING STARTED GUIDE
Overview of this guide
This guide provides instructions on how to connect up your Envoy
transceiver, and how to perform basic setup and operating tasks. It
assumes that you have limited knowledge of HF communication
and of using an HF transceiver.
Extensive reference material is provided on the CD at the back of
this guide.
NOTE: A range of options and accessories is available for
the Envoy transceiver. For more information contact
your Codan representative or refer to the product
catalogue that is applicable to your transceiver.
This guide contains the following sections:
Introduction—provides an overview of the components of the
transceiver system
Using the wizard—describes the steps in the wizard that are used
to set up the transceiver
Operating the transceiver—describes how to operate the
transceiver and how to make calls
Adding a contact—describes how to add a contact
Navigating the menu structure—describes how to navigate the
menu structure and perform basic selection and editing functions
Structure of information—describes the building blocks of
information in the transceiver
Installing the transceiver—describes how to mount and connect the
transceiver in mobile and fixed stations
Specifications—provides a list of specifications for the transceiver
Compliance—provides mandatory compliance information
To Next Page
Loading...
Need help?
General
