USING THE WIZARD
USING THE WIZARD
16 ENVOY® TRANSCEIVER GETTING STARTED GUIDE
Using the wizard
The wizard should start automatically when a new transceiver is
powered up for the first time.
Figure 5: Wizard Startup screen
NOTE: If the wizard screen doesn’t launch automatically,
follow the instructions below. If your transceiver has
been profiled using the TPS System Programmer,
the wizard may not be available.
NOTE: For information on specific entries in the wizard,
please see the Reference Manual (Codan part
number 15-04176-EN issue 7).
To use the wizard:
1 Press PTT, then press (Menu) to return to the top
level of the menu structure.
To Next Page
Loading...
