To Next Page

To Previous Page

USING THE WIZARD

ENVOY® TRANSCEIVER GETTING STARTED GUIDE 17

1 Highlight the icon for the wizard ( ), then press

(OK).

If the icon is not visible, then the wizard is not available as

the transceiver has been programmed already with a

non-basic profile.

1 Press (Yes) to confirm that you want to start the

wizard.

If you want to bypass the wizard, press (No).

Selecting a language

NOTE: This step in the wizard is shown if you have multiple

languages available.

To select a language:

1 Press or to scroll to the language that you want to use

on the control point, then press OK.

NOTE: The label above the key appears in the

selected language.

1 Press (Save) to save the information.

Setting the time and date

To set the time and date:

1 Press or to select the time zone that you want to use.

1 Press to move to the Daylight Saving entry.

1 Press or to select the time that you want to use.

1 Press to move to the Local Time entry.

Codan Envoy Getting Started Guide

Other manuals for Codan Envoy