Codan Envoy Getting Started Guide

USING THE WIZARD
USING THE WIZARD
ENVOY® TRANSCEIVER GETTING STARTED GUIDE 27
1 If you want to add another call for the contact, press
(Yes), then repeat the steps for adding a call.
If you do not want to add another call, press (No).
1 If you want to add another contact, press (Yes), then
repeat the steps for adding a contact.
If you do not want to add another contact, press (No).
1 Do one of the following:
• If you want to select an antenna, continue from
Selecting an antenna on page 27.
• If you do not want to select an antenna, press
(Close), then continue from Selecting a peripheral
device on page 28.
Selecting an antenna
Each type of antenna has a specific requirement for tuning, and the
transceiver uses a different protocol for each one. You must select
the type of antenna that is used in your station so that the
transceiver knows how to tune the antenna. Some antennas, such as
broadband antennas, do not require tuning.
To select an antenna:
1 Press or to scroll to the antenna type that you want to
use, then press OK.
1 Press (Save) to save the information.
1 Do one of the following:
• If you want to connect an accessory to the GP port
connector of the RFU, press (Yes), then
continue from Selecting a peripheral device on
page 28.
• If you do not want to connect an accessory,
press (No), then press OK to close the wizard.

Codan Envoy Specifications

General

Brand	Codan
Model	Envoy
Category	Transceiver
Language	English