OPERATING THE TRANSCEIVER
THE CHANNEL SCREEN
32 ENVOY® TRANSCEIVER GETTING STARTED GUIDE
Figure 6: Channel screen
NOTE: If you cannot transmit on the channel, Inhibit is
shown as the Tx frequency.
If the transmit and receive frequencies are the same, the frequency
is only shown on the right side of the screen. The Rx/Tx indicator
shows whether the transceiver is receiving (green) or transmitting
(red). The more bars that are shown, the higher the signal strength.
The status area of the screen provides six separate areas in which
you can show information that is relevant for your operations. Your
system administrator can choose the information that is shown in
each status area. If encryptor/scrambler options are enabled, this
information is shown in the top line of the status area (status areas
1 and 2). Any selections that have been made are discarded.
NOTE: For information on how to set up what is shown in
the status areas, please see the Reference Manual
(Codan part number 15-04176-EN issue 7).
channel name
Tx/Rx frequency
status areas
menu bar
status bar
mode
mute type
indicator
(highlighted
when mute is on)
call type
icon
Tx power
setting
signal
strength
indicator
Rx/Tx
indicator
left software key
right software key
volume indicator
missed call icon
To Next Page
Loading...
Need help?
General
