USING THE WIZARD
USING THE WIZARD
22 ENVOY® TRANSCEIVER GETTING STARTED GUIDE
To enter a self address:
1 Enter the address that you want to use.
You can enter up to six digits, or you may leave the self
address blank if a peripheral device has its own self address
set.
NOTE: Addresses ending in one or more 9 or 0 digits
have a special function in Selcall HF
networks.
1 Press (Save) to save the information.
NOTE: The wizard automatically allocates this self
address to the default HF networks: Selcall
and CALM (if FED-STD-1045 ALE or
MIL-STD-188-141B ALE option is
installed).
1 Do one of the following:
• If you want to add a contact, press (Yes), then
continue from Adding a contact on page 22.
• If you do not want to add a contact, press (No),
then continue from Selecting an antenna on page 27.
Adding a contact
A contact is a person or organisation that you want to call, and for
which you want to pre-define the method of calling. You may be
able to contact the same person or organisation via a number of
different methods. When you set up the contact, you define each
method as a separate call for the contact.
To Next Page
Loading...
