OPERATING THE TRANSCEIVER
USING DIGITAL VOICE
ENVOY® TRANSCEIVER GETTING STARTED GUIDE 71
NOTE: When transmitting via a DV option, listen for
the Tx ready beep after you have released
PTT before you hold PTT again.
CAUTION: When transmitting with the AES-256 DV
Encryptor, you should hold PTT, wait 2 sec,
speak, wait 2 sec, then release PTT.
If you have a DV option with the AES-256 Encryption
upgrade installed, or you have the AES-256 DV Encryptor
installed, the transceiver will also go secure/clear when
SEC is pressed.
Figure 19: Channel screen showing secure/clear status
for all encrypted digital voice
Analogue (in Rx)
digital voice
data rate
secure index
for AES-256
secure key
digital
key prefix
Clear (in Rx)
To Next Page
Loading...
Need help?
General
