OPERATING THE TRANSCEIVER
SCANNING CHANNELS
40 ENVOY® TRANSCEIVER GETTING STARTED GUIDE
Switching scanning on or off
To switch scanning on or off:
1 Press SCAN.
If a call is not in progress, scanning is toggled on or off.
If a call is in progress, the call is ended and the transceiver
begins scanning.
If a call from a modem (or any other peripheral device) is in
progress, you are prompted to break the system lock to
resume scanning.
NOTE: When scanning is switched on, mute is also
switched on.
NOTE: If you press PTT while the transceiver is
scanning, the scan is stopped.
Pausing scanning
To pause scanning:
1 Do one of the following:
• To pause scanning on the last-selected channel,
press OK.
• To pause scanning and scroll to another channel,
press or .
The channel/modes through which you can scroll are those
in the scan tables that are being scanned. They are not listed
alphabetically but in the order in which they are being
scanned.
If you do not press a key within 30 sec, the transceiver
automatically resumes scanning, by default.
To Next Page
Loading...
Need help?
General
