Codan Envoy Getting Started Guide

OPERATING THE TRANSCEIVER
USING A CROSSPATCH
114 ENVOY® TRANSCEIVER GETTING STARTED GUIDE
Using a crosspatch
Overview of the 3031 Crosspatch
The 3031 Crosspatch is a device that connects an HF
communication system with a VHF or UHF communication
system.
NOTE: The 3031 Crosspatch may only be used via the RFU
GP port connector. It is not supported via the
Console GP port connector.
NOTE: The use of the CIVS voice scrambler is not
recommended across VHF/UHF to HF
communication links.
The operating mode of the crosspatch may be controlled directly by
the transceiver, or by using DTMF commands on a DTMF-capable
VHF/UHF transceiver.
The crosspatch may be active, on standby, or switched off. The
status of the crosspatch is shown in the status bar, and you can set
the status to be shown in one of the status areas.
NOTE: For information on how to set up what is shown in
the status areas, please see the Reference Manual
(Codan part number 15-04176-EN issue 7).

Codan Envoy Specifications

General

Brand	Codan
Model	Envoy
Category	Transceiver
Language	English