OPERATING THE TRANSCEIVER
MUTING THE TRANSCEIVER
42 ENVOY® TRANSCEIVER GETTING STARTED GUIDE
Muting the transceiver
When the transceiver is set to a channel or is scanning channels,
and mute is switched off, you hear on-air signals on each channel.
If you do not want to listen to this, you can silence the transceiver
by switching on mute.
You can set the mute to switch off when a voice signal or any other
calling activity is detected (voice mute V), or only when a call
addressed to your station is received (selcall mute S). Your choice
of voice or selcall mute depends on whether or not you have to
detect voice signals, and how much noise and traffic you want to
hear. When digital voice is active and scanning is switched off or
paused, you can also set the mute to switch off only when a secure
or clear digital voice signal is detected (digital voice mute D). The
voice signal is output to the speaker connected to the RFU or desk
console speaker.
Switching mute on or off
To switch mute on or off:
1 If you are using a 2220 Handset or 2230 Desk Console,
press (Mute) on the channel screen, scanning screen,
or free-tune screen.
1 If you are using a 2221 Handset:
•Press (Options).
• Press or to scroll to the Mute On|Off option.
•Press (Select).
The V or S in the status bar of the channel screen is
highlighted when mute is on.
To Next Page
Loading...
Need help?
General
