OPERATING THE TRANSCEIVER
SELECTING A CHANNEL FROM A CHANNEL GROUP
36 ENVOY® TRANSCEIVER GETTING STARTED GUIDE
Selecting a channel from a channel
group
If channel grouping is enabled in Settings > Control Point >
Channel Grouping and you have allocated channels to groups,
indicated by ... after a channel group name or in front of the channel
name, you may have to switch to another channel group to find the
channel that you want to select.
NOTE: Any channels that are not assigned to a channel
group appear at the top level with the channel group
names. These channels are selected by scrolling to
the channel.
NOTE: You can set the name of the current channel group to
show in a status area of the channel screen.
To select a channel from a channel group:
1 Press PTT to exit to the channel or scanning screen.
1 If the transceiver is scanning, press SCAN to switch off
scanning.
1 If you are at the channel group level, which may include
ungrouped channels, press or to scroll to the channel
Channel level (within a group)
Channel group level
and ungrouped channels
channel group name
To Next Page
Loading...
Need help?
General
