COMPLIANCE
EMC AND SAFETY NOTICES
ENVOY® TRANSCEIVER GETTING STARTED GUIDE 199
To ensure that compliance with the EMC Directive is maintained:
1 Use standard shielded cables supplied from Codan (where
applicable).
1 Ensure the covers for the equipment are fitted correctly.
Electrical safety
To ensure compliance with the European Low Voltage Directive is
maintained, you must install and use the Envoy transceiver in
accordance with the instructions in the Envoy transceiver Getting
Started Guide and the Envoy transceiver Reference Manual.
When using equipment that is connected directly to the AC mains
these precautions must be followed and checked before applying an
AC mains supply to the unit.
To ensure electrical safety:
1 Use the standard AC mains cable supplied.
1 Ensure the covers for the equipment are fitted correctly.
CAUTION: If it is necessary for a qualified electronics technician
to remove the covers during servicing, they must be
refitted correctly before using the equipment.
WARNING: A protective earth connection must be included in
the mains wiring to the 3020 Transceiver Supply.
WARNING: The protective cover must always be fitted when the
3020 Transceiver Supply is connected to the AC
mains.
To Next Page
Loading...
Need help?
General
