Codan Envoy Getting Started Guide

USING THE WIZARD
USING THE WIZARD
ENVOY® TRANSCEIVER GETTING STARTED GUIDE 23
To add a contact:
1 Enter the name that you want to use for the contact, then
press (Add Call).
The HF Network entry is highlighted.
The HF network defines the call system and self address that
is used by your station when the call is made.
1 Press or to select the HF network that you want to use.
1 Press to move to the Call Type entry.
1 Press or to select the call type that you want to use.
NOTE: The call type that you select affects
information that you can enter for the
remainder of this call.
1 If you are adding:
• a Selective, Channel Test, Emergency, Get Position
or Send Position call, continue from Adding a simple
call on page 23
• a Message call, continue from Adding a Message
call on page 24
• a Phone call, continue from Adding a Phone call on
page 26
Related links:
Contacts on page 129
Adding a simple call
A simple call is a call that requires an address only at this stage of
the definition process.
To continue with adding a Selective, Channel Test, Emergency,
Get Position or Send Position call:
1 Press to move to the Address | Selcall Address |
ALE Address entry.

Codan Envoy Specifications

General

Brand	Codan
Model	Envoy
Category	Transceiver
Language	English