OPERATING THE TRANSCEIVER
SETTING THE BASICS
ENVOY® TRANSCEIVER GETTING STARTED GUIDE 45
Setting the basics
Setting the time and date
The transceiver is set to UTC time in the factory. You set the local
time and time zone for the location of the control point. This feature
is useful if you have a communication network that spreads over
several time zones, or you need to time stamp your transmissions
according to the current time at longitude zero.
To set the time and date:
1 From the main menu, select (General), then (Time
and Date).
1 Press (Set).
1 Press to move to the Time Zone entry.
1 Press or to select the time zone that you want to use.
1 Press to move to the Daylight Saving entry.
1 Press or to select the time that you want to use.
1 Press to move to the Local Time entry.
1 Press to enter edit mode for the local time.
1 Press or to scroll to the value that you want to set, then
press to move to the next item.
1 Repeat this for minutes, seconds and AM/PM values.
1 Press (Save) to save the local time.
1 Press to move to the Local Date entry.
1 Press to enter edit mode for the local date.
1 Press or to scroll to the value that you want to set, then
press to move to the next item.
1 Repeat this for the day/month and year, as required.
1 Press (Save) to save the local date.
To Next Page
Loading...
Need help?
General
