To Next Page

To Previous Page

USING THE WIZARD

ENVOY® TRANSCEIVER GETTING STARTED GUIDE 21

1 Do one of the following:

• If you want to scan all of the channels in the

transceiver that have a USB mode, press

(Yes), then continue from Entering a self address on

page 21.

• If you want to choose the channels and modes that

you want to scan, press (No), then continue

from Adding channels to a scan table on page 21.

Adding channels to a scan table

To add channels to a scan table:

1 Press or to scroll to the channel that you want to add,

then press OK.

1 Press or to select the mode that you want to use.

1 Select more channels, as required.

1 Press (Save) to add these channel selections.

1 Continue from Entering a self address on page 21.

Entering a self address

A self address is used by other stations to call your station. For

example, if the self address of your station is 1234, operators at

other stations enter the address 1234 when they want to make a call

to you.

Codan Envoy Getting Started Guide

Other manuals for Codan Envoy