Codan Envoy Getting Started Guide

USING THE WIZARD
USING THE WIZARD
20 ENVOY® TRANSCEIVER GETTING STARTED GUIDE
1 To select a mode:
• Press to view the list of available modes.
• Press or to scroll to the mode that you want to
use, then press OK.
When the check box is selected, the item is enabled.
When the check box is clear, the item is disabled.
• Select other modes, as required.
NOTE: The modes that you select become the
allowed modes for this channel. In a
scan table, you can duplicate a channel
and select another of the allowed
modes.
•Press (Save).
1 If you want to review the information that you have entered,
press or to move through the entries.
1 Press (Save) to save the information.
1 Do one of the following:
• If you want to add another channel, press
(Yes), then repeat these steps.
• If you do not want to add another channel,
press (No).
The channels that you enter may be allocated to a scan table.
A scan table enables you to manage how these channels are
scanned using one set of properties.
1 Do one of the following:
• If you want to add a scan table, press (Yes).
• If you do not want to add a scan table, press
(No), then continue from Entering a self address on
page 21.

Codan Envoy Specifications

General

Brand	Codan
Model	Envoy
Category	Transceiver
Language	English