CONTACTS
ADDING A CONTACT
136 ENVOY® TRANSCEIVER GETTING STARTED GUIDE
NOTE: This entry is not available for Phone calls.
1 To select a channel:
• Press to view the list of available channels.
• Press or to scroll to the channel that you want
to use, then press OK.
A is shown next to the channel/mode.
• Press or to change the mode, if required.
NOTE: If you are not able to select a different
mode, then only one mode is allowed
for this channel. If you want to use a
different mode, go to the relevant scan
table, duplicate the channel, then
select the new mode for this channel.
•Press (Save).
1 If you want to add another call, press (Options),
scroll to Add Call, press (Select), then repeat the
steps for adding a call.
To Next Page
Loading...
