OPERATING THE TRANSCEIVER
CALLING
ENVOY® TRANSCEIVER GETTING STARTED GUIDE 53
1 If you do not want to use the HF network shown at the top
right of the screen:
•Press (Options).
• Scroll to HF Networks, then press (Select).
• Scroll to the HF network that you want to use, then
press OK.
1 Press or to select the Selective call type if it is not
selected.
NOTE: If you want to test the quality of the channel
before you make the actual call, hold CALL
first.
1 Do one of the following:
• To repeat the call to the last address used,
press CALL.
• To call a different station, enter the address, then
press CALL.
• To repeat or return a call from the Call Log, press
to scroll to the call, press or to select your
required call type, then press CALL.
• To use an ALE address syntax in an ALE/CALM HF
network, press (View), scroll to ALE,
press (Select), scroll to the syntax that you
want to use, then press CALL.
To Next Page
Loading...
Need help?
General
