CDM-570A/570A Satellite Modem with Optional Packet Processor
Revision 5
Dedicated Management Port Feature Q–9 MN-CDM570A
4. When in Router Mode, you must use Route Tables to allow local and remote M&C
access (Figure Q-9). To restrict M&C access as Local ONLY, you must either delete the
existing route, or not configure a route, destined to remote unit’s M&C subnet.
a. From the Serial CLI Main Menu, press ‘R’ to open the Route Table menu.
b. On Route Table menu, press a number (e.g., ‘3’) to edit an assigned Route, or press
‘D’ to delete an assigned route.
Figure Q-9. CDM-570A/570AL Route Tables
To Next Page
Loading...
